Thingiverse
PS5 Controller Wall Mount - Dangle edition
by dazzhole
0
Downloads
0
Likes
0
Makes
Just took the original backplane and threw some magnet holes in the back to mount to the side of my NZXT h210 case.
Magnets were a good friction fit but probably could have made holes a bit bigger and used some glue. i used 10mm magnets and added as many up until the mount didnt move around too much. Do at me if you use this and it borks a hdd or something. use the common sense.
Ive included the original PS5 mount and also a plain, unbranded mount from DrKronos: https://www.thingiverse.com/thing:5811827
Excuse the dust.
Magnets were a good friction fit but probably could have made holes a bit bigger and used some glue. i used 10mm magnets and added as many up until the mount didnt move around too much. Do at me if you use this and it borks a hdd or something. use the common sense.
Ive included the original PS5 mount and also a plain, unbranded mount from DrKronos: https://www.thingiverse.com/thing:5811827
Excuse the dust.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
