Thingiverse
PSE USB mount for SimLab Vertical
von RCHeliGuy
2
Downloads
3
Likes
0
Makes
This is a two piece DIN USB mount for a Precision Sim Engineering Wheel through a SimLab Vertical mount without the cable touching the opening.
it has a front face that attaches to the rear section with the USB mount.
It may be compatible with other round DIN designs. The M3 bolt holes are on a 20mm OC square pattern. and the center clearance is about 21mm.
The two halves are bolted together using 7x M3x16 socket head screws and square nuts.
The square holes are pressure fit require needle nose pliers to press into place. An ice pick or very small screwdriver can help to center the nuts.
The USB mount takes 4 x M3x20mm bolts and locknuts to secure the DIN face
it has a front face that attaches to the rear section with the USB mount.
It may be compatible with other round DIN designs. The M3 bolt holes are on a 20mm OC square pattern. and the center clearance is about 21mm.
The two halves are bolted together using 7x M3x16 socket head screws and square nuts.
The square holes are pressure fit require needle nose pliers to press into place. An ice pick or very small screwdriver can help to center the nuts.
The USB mount takes 4 x M3x20mm bolts and locknuts to secure the DIN face
RCHeliGuy veröffentlicht auch auf
47 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!