Thingiverse
PSU case
by digimatic
397
Downloads
278
Likes
1
Makes
Thick walled case for equipment PSU's
PSU mounting holes 3mm diameter in a 9.5 x 17.5cm square pattern (check the bottom of your PSU for compatible mounting points)
if you need different mounts then get in touch and I'll share out the Design files.
5mm thick walls, this is a long print :)
Has additional holes for IEC type switch/socket and a 16mm hole to take aviation type 2 pin connector or a panel mount cable grommet.
PSU mounting holes 3mm diameter in a 9.5 x 17.5cm square pattern (check the bottom of your PSU for compatible mounting points)
if you need different mounts then get in touch and I'll share out the Design files.
5mm thick walls, this is a long print :)
Has additional holes for IEC type switch/socket and a 16mm hole to take aviation type 2 pin connector or a panel mount cable grommet.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!