Thingiverse
PSU case
door digimatic
397
Downloads
278
Likes
1
Makes
Thick walled case for equipment PSU's
PSU mounting holes 3mm diameter in a 9.5 x 17.5cm square pattern (check the bottom of your PSU for compatible mounting points)
if you need different mounts then get in touch and I'll share out the Design files.
5mm thick walls, this is a long print :)
Has additional holes for IEC type switch/socket and a 16mm hole to take aviation type 2 pin connector or a panel mount cable grommet.
PSU mounting holes 3mm diameter in a 9.5 x 17.5cm square pattern (check the bottom of your PSU for compatible mounting points)
if you need different mounts then get in touch and I'll share out the Design files.
5mm thick walls, this is a long print :)
Has additional holes for IEC type switch/socket and a 16mm hole to take aviation type 2 pin connector or a panel mount cable grommet.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!