PSVR2 Wall Mount

I came across this design from Rak3tenmann and loved it, but it was too large to print on my Voxelab Proxima 6.0 resin printer. So I chopped up the original file into smaller parts making it easily printable. I was able to print the left and right sides at one time on the build plate.

I also created a screw hole template to make it easier to get them both mounted. As shown in the pictures, I just screwed the template into the wall, then removed it and screwed in each side. It's a decently snug fit, but the template is just what I used to keep it close to the original design width.

I printed this with Anycubic Basic Gray resin, no supports were needed when the arms were standing straight up.

I've included 2 sets of arms. The plain set are directly from the original design Rak3tenmann did. The etch set has the Playstation symbols imprinted into the outer sides of the arms. I didn't print those myself, but I figured it'd be a nice touch.