Thingiverse

PTFE Tube Holder

di icefire

43 Download

26 Likes

0 Makes

This is a very simple PTFE Tube holder which can be easily attached to a 20mm aliminum extruded profile with a 5mm nut width. I used mine to guide the PTFE tube for bowden setup along the frame of my mendelmax 2.0 but the part can be attached to any 20mm extruded profile.

The fit is very tight and snug. If done carefully, the holder can be installed and removed about 5 times with no damage.

Just fit the base to the extruded profile, put your PTFE tube in the slot and then slide the locking cap in place. Can be used also for cable routing, etc.

Use with ABS only. PLA is not elastic enough and may break.