Thingiverse
PugLight
von Zatamite
7
Downloads
8
Likes
0
Makes
Short and squat pug flashlight.
5-6 snug fitting pieces.
Cree xp led (xp-e or xp-l) on star
simple solders on star
switch still to be added.
Uses single cr123a battery.
Minimal Material.
The walls may seem thin on the body of the pug light but once all the components are assembled/installed the flashlight is very rigid. I am considering thinning out the walls on the parabolic front end just to save material.
Printed in PLA... and the parts remain tight enough. You may want to choose something a bit more stiff/strong.
Battery cover will be worked up. I'm just on to other things temporarily
5-6 snug fitting pieces.
Cree xp led (xp-e or xp-l) on star
simple solders on star
switch still to be added.
Uses single cr123a battery.
Minimal Material.
The walls may seem thin on the body of the pug light but once all the components are assembled/installed the flashlight is very rigid. I am considering thinning out the walls on the parabolic front end just to save material.
Printed in PLA... and the parts remain tight enough. You may want to choose something a bit more stiff/strong.
Battery cover will be worked up. I'm just on to other things temporarily
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
