Slicer Discord
3DSEARCH / Replacement Parts / Pull Start Handle
Pull Start Handle – 3D printable model from Thingiverse Thingiverse
Pull Start Handle – Bild 1 Pull Start Handle – Bild 2 Pull Start Handle – Bild 3 Pull Start Handle – Bild 4 Pull Start Handle – Bild 5 Pull Start Handle – Bild 6
Replacement Parts

Pull Start Handle

by _Isaiah_ · Replacement Parts
37 Downloads
41 Likes
1 Makes
Go to Model
My brother was converting his lawn mower engine into a pull start, and I offered to print a handle for him. I thought for sure there would be a suitable model available online, but to my surprise none of the models I found were satisfactory. So, of course, I designed my own. It prints without supports, so it's easy to print and requires little or no clean up. This handle is about three inches from side to side, and has a quarter inch hole through it. I printed mine out of PLA, which works just fine with my brother's setup. However, if it were used on an engine where it is retracted and sits on the engine while it's running, I would recommend printing it with ABS so that it can withstand the engine's heat. This handle could also be used for other applications, such as a garage door pull or an attic hatch handle. Enjoy!
Category
Replacement Parts
Source
Thingiverse
Published
What you need to print this: Intermediate Medium confidence
Why?
no supports · very large print
Support-free Single piece May need scaling or splitting
Supports 0/3
Assembly 0/3
Settings 1/3
Bed size 3/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA, ABS
Min. bed size
300 mm (Extra large)
Software
Cura, PrusaSlicer, or similar
Frequently Asked Questions
Which 3D printer is suitable for Pull Start Handle?
Any FDM printer should handle Pull Start Handle just fine. It's been printed on machines like Bambu Lab X1C, Prusa MK4, Creality K1 Max, Anycubic Kobra Max. A minimum build volume of 300 mm is recommended.
Does Pull Start Handle need supports when printing?
No supports needed for Pull Start Handle — it's designed to print clean off the bed.
What file format is Pull Start Handle available in?
Pull Start Handle is available in STL format. These files can be opened and sliced using free software such as Cura, PrusaSlicer, Bambu Studio, or OrcaSlicer for FDM printing, or ChiTuBox and Lychee Slicer for resin printing. The download is provided through Thingiverse.
Is Pull Start Handle free to download?
Yes, Pull Start Handle is available as a free download through Thingiverse. Always check the license on the original platform to understand commercial use, remixing, and attribution requirements.
No ratings yet
No comments yet – be the first!

Similar Models

4 Suggestions
Loft Hatch Handle
Loft Hatch Handle
by stevosteve
↓ 1 ♥ 4
Handle I made for my attic hatch
Handle I made for my attic hatch
by Robotbeat
↓ 7
Attic Access Panel Handles and Hatch Dogs
Attic Access Panel Handles and Hatch Dogs
by MyStoopidStuff
↓ 21 ♥ 15
Attic Access Panel Handles and Hatch Dogs
Attic Access Panel Handles and Hatch Dogs
by mystoopidstuff
↓ 14 ♥ 19
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
· Impressum · Privacy
DE EN FR ES IT NL

Add to Collection