Thingiverse
Pumpkin Stem Costume Headpiece
por dsmith77
2
Descargas
3
Likes
0
Makes
A pumpkin stem made as the headgear for a pumpkin costume. Two options for wearing: glue the non-hole version to some ribbon. Thread ribbon through the version with the hole.
The version with the hole is about 2x the version without the hole. Resize as needed.
I recommend printing both without supports. For the one with the hole, you will have a little clean up at the opening of the hole on both sides but this is better than a lot more cleanup removing support material further in. The material will bridge the hole internally just fine.
The version with the hole is about 2x the version without the hole. Resize as needed.
I recommend printing both without supports. For the one with the hole, you will have a little clean up at the opening of the hole on both sides but this is better than a lot more cleanup removing support material further in. The material will bridge the hole internally just fine.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
