Thingiverse
Pushrod End
door rajazo
1
Downloads
2
Likes
0
Makes
This simple Pushrod End replace the Z bend type of ending and it is easy to open and release on tigh spaces, as rudder or elevator.
You need to insert the printed piece before bend the pushrod or slid from the straight end of the pushrod
PLA+ suggested for printing at 100% infill and 2 perimeters.
The size is for 0,8mm piano wire, but could be scaled up if it needed.
You need to insert the printed piece before bend the pushrod or slid from the straight end of the pushrod
PLA+ suggested for printing at 100% infill and 2 perimeters.
The size is for 0,8mm piano wire, but could be scaled up if it needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
