Pushrod Keepers

While fitting out my recently completed 3DLabPrint Spitfire XVI I found I didn't have any keepers to suit the pushrod 18swg (1.2mm) wire I was using, so I made some. Also the aileron and elevator control horns on the Spitfire are a lot thicker than standard so I made a range of sizes: 2mm for servo horns, 4mm for the Spitfire and 3mm to fill in the gap.

They are designed to be held in place with 1.6mm zip ties.


##### UPDATE 18/08/17
I've added three extra sizes for use with 1mm wire.

##### UPDATE 04/09/17
I've added a set for use with 2.5mm zip ties.