Thingiverse
Puzzle Test
von thumper06
3
Downloads
1
Likes
0
Makes
When printing holes and female puzzle pieces there is usually some shrink.
This is a puzzle test to find the amount that holes and female puzzle puzzle pieces must be expanded to fit together with rods and male puzzle pieces.
1. print the male puzzle piece
2. use Freecad to modify the female puzzle piece offset (currently set to 0.4mm)
3. print the female puzzle piece with different offsets until the pieces fit together the way you want
You will need Freecad to run this test
This is a puzzle test to find the amount that holes and female puzzle puzzle pieces must be expanded to fit together with rods and male puzzle pieces.
1. print the male puzzle piece
2. use Freecad to modify the female puzzle piece offset (currently set to 0.4mm)
3. print the female puzzle piece with different offsets until the pieces fit together the way you want
You will need Freecad to run this test
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
