PvC Printer Enclosure Internal Webcam Mount

This is a Platform that can be slid onto a Half inch PVC Pipe for you to place your webcam on so that it can be mounted Inside your 3D printer Enclosure.

I built some enclosures for my Ender 5 Plus and Ender 3 using half inch PVC pipe and some 3 way joints to make the frame with some Clear Vinyl for the "enclosure" it's self the thing is the enclosure being larger than the printers left no room on my desk for the boxes I had my webcams sitting on aimed at them for Octoprint, Plus the vinyle would distort the image a bit.... So after some searching i found Ronthomps Webcam mount and loaded it through tinkercad to make it Solid except for a few openings to allow the webcams cord to feed through. I repurposed it to work as a little platform to sit your webcam on in the corner of your enclosure aimed at your print bed. The only thing you will need is some electrical tape, painters tape, etc to wrap on the pvc pipe just below the mount so it can not slide down.

**I've included 2 d