Python AMS - Dovetail Test Pieces

Support All my designs and mods on MakerWorld are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :) https://www.paypal.me/humebeamengineering About The tolerances for the Python AMS dovetails are generous at 0.15 mm so most will have no issues at all just printing away. However, if you're overextruding (flow ratio too high) or use some experimental slicer settings you may have difficulties joining the modules together. You're not meant to use a mallet to join them, they should slide together with little effort. This is a small set of test pieces (around 6 g) to print before printing the big Python AMS parts. Make sure you dial in flow correctly before you start, we've seen a few Python prints that were overextruded (although it's rare) so avoid that. The problem then is you can't join the dovetail joints and therefore assemble properly without sandi