Python Silica Gel Box Upper/Lower (Connectable)

Update 03/06/2025: Uploaded a M14 XL Silica box for the top slot. The previous box was too tall for the top slot and could not get the lid to close without closing the box first. This version will sit low enough for the lid to close easily, as well as leave room for a light bar should you make that modification. I aslo revised the supports for this one, so they will be easier to pull off. Big thanks to @formergeek for letting me know about this, as well as test printing for me and sending me photos! Update 01/18/2025: I have combine the XL M14 plug version to make a slightly bigger connectable silica box. If you have the three xl silica boxes made by Humebeam in the Python, the lower xl connectable will not fit. I use the Xl in the upper slot and normal in the lower. If you do not have the Xl silica boxes, then they will both fit as normal. This is also in the description of the print profile if you are confused as to which one is which. Thank you again, I appreciate everyone's fee