Thingiverse
Q bicycle bell hammer
von marcin10
0
Downloads
0
Likes
0
Makes
This is a striker for a Q-type bicycle bell.
The photo also shows the dimensions of the spring, which you’ll need if you want to replace it.
I don’t have a photo of the 3D-printed part itself, but it has been tested and works just like the original.
Print it on its side.
The photo also shows the dimensions of the spring, which you’ll need if you want to replace it.
I don’t have a photo of the 3D-printed part itself, but it has been tested and works just like the original.
Print it on its side.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
