Qidi E3d Bowden Conversion

This is an upgrade for the qiditech1 3d printer all the hardware is m3x1.5 you can use nuts or not. print in abs or similar at 100%infill for longevity.

I made this so I could use a volcano E#D v6 that I had leftover from a build. This mod can be done without any firmware changes you will need to drill and tap the heater block to accept the standard qidi thermistor some wiring required. I am currently running a volcano 1.2 nozzle with no problems. You will need to make sure the heater you buy is a 24v. I am running a 12v but it is not recommended.

I will suggest that you get simplify3d for the actual settings and slicing it makes this setup much easier.