Qidi Plus4 1" Riser

This is a Fully enclosed 1in riser for the Qidi plus4 printer, Consisting of 6 separate pieces. This has slots done over the grab handles and along the back for material reduction (this is a hefty print as it is) but can be used to put flashdrives, ect, as well. Tolerancing on the V slots between pieces is tight (slowly wiggle back and forth or use a small mallet on the bottom and they will press together) so make sure to consider this when setting print parameters. I printed out of PLA-CF to get a matte finish and make sure that there was not going to be any issues with the chamber temps this machine is capable of. The USB port is fully accessible and the factory filament holder can be used with the larger diameter slip on dowel that comes pre-installed on the printer with 1kg spools. Good luck! EDIT: 7/28/25 A new USB corner piece has been uploaded that is a direct replacement for the original design and will accommodate the new USB hub required for the Qidi Box. This piece has been