Qidi Tech 1 Live Leveling Guide

This is based off of the CR-10 live leveling guide. It's not perfect, but in my opinion more precise then the leveling card you get with the printer. You can get the gist of how live leveling works by watching this video: https://www.youtube.com/watch?v=gkZUAyTxU1Q

Set layer height to 0.2mm and speed to about 20mm (slow is good... you wanna have time to adjust appropriately during each section). Also, I recommend you get a bright LED to shine towards the nozzle so you can see how well your adjustments are affecting the print.

I suggest raising ever so slightly (turning left) _just_ until no filament is laying down... then lower (turning right) about 2/5 to 3/5 of a full turn, so that the filament is laying out consistently, but isn't globbing up around the nozzle.

**Note:** This is only for one extruder. I'd like to eventually add something for dual extruders when I reach that juncture.