Thingiverse
Quad Gate
von Dnard
4
Downloads
4
Likes
0
Makes
Print on Creality, the 10 inch gate is a challenge for my tiny whoop, good practice. The larger one you'll have to print it four times to make a complete one. It slides together, no glue needed. I used 3M Command Strips for easy removal. I used glow in the dark PLA but not very bright.
I added a gate hanger for the larger gate, used with 3M command strip for the wall then slide the flat part of the gate into it..
I added a gate hanger for the larger gate, used with 3M command strip for the wall then slide the flat part of the gate into it..
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
