Thingiverse
Quad Holder
von Dnard
1
Downloads
1
Likes
0
Makes
Printed this using .8mm nozzle at .3, the surface on this one is rough maybe use a smaller nozzle or use .2. uses a command strip to hold it in place. Put the quad on first then the controller. Only support was for the command strip holder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
