Quadcopter Drone

Updates - 1/01/2018
Added landing gear to protect battery and eventually camera from hard landings. If you strap the batteries to the top of the drone this won't be as much of a problem. The landing gear consists of four 3" long 3/16" bolts (apologies for the imperial units, I wanted to use M5 but this was all I could find). Attached to the base of these bolts is a front spring, back spring and two side springs. They are designed to absorb some shock if the drone lands at an angle, and will prevent too much torque from being applied to the arms. These springs will break easily, but they only take 20 minutes to print, and prevent other more important things form breaking

Added some vents below the motor mounts to prevent overheating. This is very important! Without these vents the motors will quickly break.

Thickened some areas on the body which were breaking to easily.



Listed below are all the parts I used. I'm pretty new to quadcopters, but it seems like most of the m