Quadcopter Frame

This is an upgrade for the G-Intrude micro quadcopter, but it may work for any quadcopter board with 3mm holes set 23mm apart.

It is intended for 7mmx20mm motors and 55mm props.

Here's my parts list:
G-Intrude Quadcopter (or derivative): https://www.amazon.com/gp/product/B010SNM4YS/
4x Hubson X4 H107L Motors: https://www.amazon.com/gp/product/B00SKVZMU4/
Hubson X4 H107 Props: https://www.amazon.com/dp/B00GZHI75C

The 7x20mm motors are a considerable upgrade compared to the ~6x12mm motors the G-Intrude comes with, so it goes without saying that you'll want a larger battery too. I'm using a 680mAh Lipo (compared to the ~100mAh stock battery), and flight times are upwards of 20 minutes.


Update: Added a modified version for 10mm diameter motors, as requested. I have not done any test prints on this version though, and I do not have 10mm motors to test with, so tolerances may be off. If that's the case, you can wrap the motors with a bit of tape for a tighter fit, or bore ou