Thingiverse
Quadcopter Peripheral Electronics Mount - CUSTOMISABLE
von dark_matterFPV
10
Downloads
5
Likes
0
Makes
Keep those top plates CLEAN! Get your peripherals mounted down on top of the stack, without needing to be secured to a blank carbon plate or the flight controller(!) with cable ties. Make replacing the top plate or removing it for maintenance a more-pleasant experience, without the need to cut cable ties or be wary of UHB tape and wires!
This mount was designed for use in RC quadcopters, but may have other applications. Customisable to suit the end-user's specific dimensional requirements, this mount facilitates easy securing of non-stackable items such as receivers and video transmitters to the top of the stack.
Tweak the parameters in Customizer! I have designed this using OpenSCAD, in order to facilitate tweaking of key parameters so that the end-user can get exactly what they require.
PARAMETERS:
pouch_gap = The pouch gap in millimetres. Must be a positive value.
standoff_bolt_diameter = The diametre of the bolt or threaded part of a standoff spacer in the st
This mount was designed for use in RC quadcopters, but may have other applications. Customisable to suit the end-user's specific dimensional requirements, this mount facilitates easy securing of non-stackable items such as receivers and video transmitters to the top of the stack.
Tweak the parameters in Customizer! I have designed this using OpenSCAD, in order to facilitate tweaking of key parameters so that the end-user can get exactly what they require.
PARAMETERS:
pouch_gap = The pouch gap in millimetres. Must be a positive value.
standoff_bolt_diameter = The diametre of the bolt or threaded part of a standoff spacer in the st
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
