Thingiverse
Quakecon Keycap
von muhteeus
55
Downloads
37
Likes
0
Makes
Quakecon Keycap v2
Row 5 DCS, row 4 was incorrect and sat wrong on the keyboard.
Print at 0.1mm layer height. Any infill.
If you have a tight first layer, you may need to trim the edges of the stem at the bottom.
Row 5 DCS, row 4 was incorrect and sat wrong on the keyboard.
Print at 0.1mm layer height. Any infill.
If you have a tight first layer, you may need to trim the edges of the stem at the bottom.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
