Quest Controller Grip 2 3 3s

Fits Quest 2 and Quest 3 and now the Q3s
might have to sand the inside some to get it to fit and slide back off to change your batteries.
pushing up with your thumb from the hole in the bottom will push the controller out. if you need to use a battery or pen to push it out. do not pull on the Quest 2 Ring it might be bad.

the hand strap can be looped to use as a knuckle strap or just loop around your wrist like before.
If you loop the strap before you slide it all the way in it will hold it against the controller and not come off.

this is still a work in progress and not 100% happy with it. but it works and your welcome to use this one.
Printed on the Ender 5 plus .04 no supports needed. i was amazed that how the Donut ring did not need any. worked fine and this was printed at speed of 100 will try faster next time. i used some 3D builder and some blinder