Quick Calibration Print

This model is designed to test several different aspects of your printer's calibration. If there are problems, then you need to take measures to adjust the slicer settings or printer calibrations as needed.So, what are you measuring?The thickness of the card at the edge is 3mm.The card is 75mm wide.50mm in the y direction.and 50mm diagonal measure using the alignment arrows.If the X, Y, or card thickness are off by more than just a few 100ths mm you should probably look into recalibrating your printer. There is a good test print and instructions for how to make adjustments to a Marlin based printer available.Each step in the recessed stairway is 0.2mm.Thin lines ranging from 0.25mm up to 3.0mmOverhang tests that range from 50-65 degrees.<img src="https://makerworld.bblmw.com/makerworld/draft/603937/2024-02-29_n928v3l8k8vo.pn