Thingiverse
QuickAndDirtyTest
door KronBjorn
3
Downloads
1
Likes
0
Makes
This is just a quick and dirty test, to see if it would be possible to make a shoe with better visibility.
I imagine a setup where you could print cones in different heights, and snap on the one you need depending on how deep you need to go in the stock.
I turned the shoe upside down, covered the hole, and glued on a 25mm tall cone.
https://vimeo.com/213424506
https://vimeo.com/213424609
I imagine a setup where you could print cones in different heights, and snap on the one you need depending on how deep you need to go in the stock.
I turned the shoe upside down, covered the hole, and glued on a 25mm tall cone.
https://vimeo.com/213424506
https://vimeo.com/213424609
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!