Thingiverse
QuickPrint Face Mask Version 7
14
Downloads
14
Likes
0
Makes
This is the Printable .stl for the QuickPrint COVID-19 Mask Version 7 (Filter Material Polycarbonate .3 Micron). Please refer to .pdf for detailed instructions
The Mask Files are also completely free located on the NIH 3D Print Exchange Located here https://3dprint.nih.gov/discover/3DPX-013971
If you found this design useful feel free to donate to my PayPal [email protected]
ATTN: YOU MUST PRINT THE MAIN BODY OF THE MASK IN TPU, AS WELL AS IN VASE MODE (WITH 2MM BRIM)
This version also includes the files for the optional face face shield. The face sheild should be cut out of a PETG film or Lexan sheet.
Inventory of parts and Printing/cutting:
Hard Shell: Print in vase mode with a 1mm nozzle -- single wall @ 1.2 width and .4mm layer height in PETG or PLA. Face side down with no brim.
Soft Shell: Print in vase mode 1mm nozzle -- single wall @ 1.2 width and .4mm layer height in TPU. Face side up with 2 birm lines for 2 layers (brim offset 0mm)
Filter Housin
The Mask Files are also completely free located on the NIH 3D Print Exchange Located here https://3dprint.nih.gov/discover/3DPX-013971
If you found this design useful feel free to donate to my PayPal [email protected]
ATTN: YOU MUST PRINT THE MAIN BODY OF THE MASK IN TPU, AS WELL AS IN VASE MODE (WITH 2MM BRIM)
This version also includes the files for the optional face face shield. The face sheild should be cut out of a PETG film or Lexan sheet.
Inventory of parts and Printing/cutting:
Hard Shell: Print in vase mode with a 1mm nozzle -- single wall @ 1.2 width and .4mm layer height in PETG or PLA. Face side down with no brim.
Soft Shell: Print in vase mode 1mm nozzle -- single wall @ 1.2 width and .4mm layer height in TPU. Face side up with 2 birm lines for 2 layers (brim offset 0mm)
Filter Housin
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
