Thingiverse
Quiver
von DeltaZ3dNS
38
Downloads
39
Likes
0
Makes
I printed the bow at 130% so that I could use M4 bolts instead of the M3 bolts that were recommended. This quiver is designed to fit the 130% model.
The quiver holds 5mm skewers.
Print them in the orientation that they sit in the STL file. if you print them so that the layers are parallel to the bending stress in the arrow holders they will break. I learned this the hard way. I have not tested quiver2. Quiver1 replaces the counter weight.
The quiver holds 5mm skewers.
Print them in the orientation that they sit in the STL file. if you print them so that the layers are parallel to the bending stress in the arrow holders they will break. I learned this the hard way. I have not tested quiver2. Quiver1 replaces the counter weight.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
