Thingiverse
Radiacode-101 case
door drezster
12
Downloads
11
Likes
0
Makes
Needed a quick and dirty case for my Radiacode and so why not share it.
Things to note:
This is a very basic enclosure, the two sides are held together mostly by luck and hope. One can add a tiniest drop of acetone (for PLA / ABS) or superglue to give it a better chance. Or some tape.
The enclosure is meant to protect against scratches, not dust, water or drops from height. I'd recommend keeping it in a grip lock bag anyway to prevent contamination.
Speaking of scratches - careful when fitting the top part over the dosimeter. The tabs might leave marks on the case because the Radiacode plastic quality is nothing to write home about.
The top part goes on first, then carefully attach the bottom case.
Might improve it in the future when needed.
Happy prospecting!
Things to note:
This is a very basic enclosure, the two sides are held together mostly by luck and hope. One can add a tiniest drop of acetone (for PLA / ABS) or superglue to give it a better chance. Or some tape.
The enclosure is meant to protect against scratches, not dust, water or drops from height. I'd recommend keeping it in a grip lock bag anyway to prevent contamination.
Speaking of scratches - careful when fitting the top part over the dosimeter. The tabs might leave marks on the case because the Radiacode plastic quality is nothing to write home about.
The top part goes on first, then carefully attach the bottom case.
Might improve it in the future when needed.
Happy prospecting!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!