Thingiverse
Rainfall Showerhead
von omnipotens
94
Downloads
77
Likes
0
Makes
Rainfall showerhead. The shower head was designed to create a rainfall effect.
Added 190mm version
The showerhead is 320x320mm size.
If you require a smaller or larger one just ask and I can resize it. Do not resize it in the slicer.
This takes about 770g of filament with 4 walls and 25% infill at 0.2 layer.
Pint upright with supports for the connector. (Use supports touching buildplate only) or it will put supports inside the shower head.
Added 190mm version
The showerhead is 320x320mm size.
If you require a smaller or larger one just ask and I can resize it. Do not resize it in the slicer.
This takes about 770g of filament with 4 walls and 25% infill at 0.2 layer.
Pint upright with supports for the connector. (Use supports touching buildplate only) or it will put supports inside the shower head.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
