Thingiverse
Ram Mount Extension
von dkcwenge
124
Downloads
83
Likes
0
Makes
This modular ram mount extension uses a 17mm ball. The "arm" portion can be swapped out depending what shape you need. A screw (M4) is used to attach the ball or the socket to the arm. If you wanted to use 8-32 screws, you could probably get it to work since the major diameter is only .006" larger than the M4.
if you need help getting the screw started into the hole, you might want to use an M4 tap (or 8-32). Otherwise, just push harder!
the printed threads do not need anything special. The tap drill diameter for the nut was increased to 0.7mm (normally fitment is .12mm). For reference, the threads are M22x1.5
if you need help getting the screw started into the hole, you might want to use an M4 tap (or 8-32). Otherwise, just push harder!
the printed threads do not need anything special. The tap drill diameter for the nut was increased to 0.7mm (normally fitment is .12mm). For reference, the threads are M22x1.5
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
