raspberry Case TinkerCAD

The original looks like a great case. Only had a few issues that were corrected:
1. One half was NOT normalized (it was floating above the print surface) FIXED
2. No indents for the case closures to latch the case closed ADDED.
3. Was only provided combined and too big for some printers- needed to be separate to print on smaller printers. FIXED.
4. Needed to be a little stronger - too easy to break. FIXED
5. Needed a break-out spot for a GPIO cable if used. ADDED

All files are consistent now. And I think I finally have it appropriately cleaned up, strengthened and printable after 4/25/14 rev!!

This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/e3YECt67i29