Thingiverse
Raspberry Pi 2 Micro SD Card holder
von twyfordm
6
Downloads
4
Likes
0
Makes
The Raspberry Pi 2 has one major flaw that I ran into - the SD card is spring loaded catch, rather than just the friction fit like the RP1 3 and 3 B+.
When the spring mechanism failed, I was inclined to throw the Pi 2 out. So I played with a design to have two pegs sit in the holes and provide a friction fit for the micro SD card.
Next iteration will likely include a proper case that incorporates this design - but it will need to snap together so the card can still be replaced/upgraded without tools.
When the spring mechanism failed, I was inclined to throw the Pi 2 out. So I played with a design to have two pegs sit in the holes and provide a friction fit for the micro SD card.
Next iteration will likely include a proper case that incorporates this design - but it will need to snap together so the card can still be replaced/upgraded without tools.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
