Thingiverse
Raspberry Pi 3.5TFT ControlBox
von kelmi92
33
Downloads
15
Likes
0
Makes
I designed this control box for my raspberry pi + 3.5TFT screen setup using octoprint. I designed the box around this case model, so you can put your raspberry in the case and then fit in this control box:
https://www.thingiverse.com/thing:1895374
I added a small gap in one of the corners to put in it the cables thath you might have attached to the R-PI GPIOs.
I made 2 version, one with an Anet A8 logo, and the other with no logo.
(I have temporarily set my camera upon the box with some sticky tack until I receive a extension cable for it).
https://www.thingiverse.com/thing:1895374
I added a small gap in one of the corners to put in it the cables thath you might have attached to the R-PI GPIOs.
I made 2 version, one with an Anet A8 logo, and the other with no logo.
(I have temporarily set my camera upon the box with some sticky tack until I receive a extension cable for it).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
