Thingiverse
Raspberry Pi 3 case
by 1911ly
17
Downloads
13
Likes
0
Makes
This is a Raspberry Pi 3 case. I designed it with Tinkercad just to prove you can make complicated designs with it. This is from scratch. It is not copied or someones design I modified. The lid snaps on and fits great.
https://www.youtube.com/watch?v=NLZGq9Faka8
It is design to have room for heat sinks top and bottom and to use a 30mm fan. Both sides of the board are cooled with this design. The air flow is forced over the top and bottom from one side and exits out the other side. It works excellent with a 30x30x7mm or similar fan
The slits in the lid are for the camera and display ribbon cables. The hole in the end are for wires to run to the GPIO header. I will add another lid that will expose the complete GPIO header strip.
I am able to print this with my machine without supports. But I would imagine it will need supports on most machines.
https://www.youtube.com/watch?v=NLZGq9Faka8
It is design to have room for heat sinks top and bottom and to use a 30mm fan. Both sides of the board are cooled with this design. The air flow is forced over the top and bottom from one side and exits out the other side. It works excellent with a 30x30x7mm or similar fan
The slits in the lid are for the camera and display ribbon cables. The hole in the end are for wires to run to the GPIO header. I will add another lid that will expose the complete GPIO header strip.
I am able to print this with my machine without supports. But I would imagine it will need supports on most machines.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
