Thingiverse
Raspberry Pi 4 Case
door JoeBowler
17
Downloads
10
Likes
0
Makes
Snap fit Raspberry pi 4 case, no screws necessary. Basically a honeycomb venting style design. There' s 3 types of tops. 1.) No slots or cutouts. 2.) Top with slots cutout. 3.) Top with slots punchouts that can be removed when needed.
The Raspberry pi 4 runs very hot and should be used with heatsinks on the chips. This minimal low profile design should be able to accomodate the heat sinks. I did not design a type with a vent or fan screw holes. The case is vented enough without a vent design. If one is sole desired I can add it upon request
The Raspberry pi 4 runs very hot and should be used with heatsinks on the chips. This minimal low profile design should be able to accomodate the heat sinks. I did not design a type with a vent or fan screw holes. The case is vented enough without a vent design. If one is sole desired I can add it upon request
JoeBowler publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!