Raspberry Pi 4 Case

My take at a Raspberry Pi 4 case with a mount for 40x10 fan.

The case has holes for rear io, sd-card, power cable(made for the official usb-c cable) and for one of the hdmi ports as I didn't need the other one. Also the AUX connector does not have a hole.

Pi is mounted with 4x m2.5 x 6mm screws and the parts are held together with 4x countersunk m2.5 x 10mm. The 10mm screws are absolute minimum lenght for those screws and I will probably go for 15mm when I order new screws again. Max length for these screw is around 30-40mm but there would be a lot of screwing included so don't use long ones :D

Fan hole is made for 40x10mm fan and the screw holes are around 4-5mm in diameter and are perfect for those screws that come with noctua fans. Designed for Noctua 40x10 fan but most likely will work with any 40x10.

Clearance between cpu and fan will accept small heatsinks. I used heat sinks with height of 6mm. Not much higher are able to fit. Max is around 10mm.