Raspberry Pi 4 cyberdeck

This face plate model is to build a touchscreen portable raspberry pi 4 computer to fit into a Nanuk 904 case. You'll need to figure out your own power wiring and programming. The other two download files are the ducting to bring outside air straight onto the raspberry pi's heat sink location. I made the duct into two parts so it could print with minimal supports. They need to be glued or ,preferably, plastic welded together after printing. Slight filing will be required on some cables and cable holes to get optimal fit, but everything should be pretty close. Follow the touchscreen's included wiring directions with its included cables to mount the pi to the screen. Mount the screen to the face plate using some small bolts. Sandwich a 40x40x10mm fan in between the face plate's duct and the duct. Tie it into place through the nearby holes and secure it however you see fit. The face late model has a hole to pull out the raspberry pi v2 camera.If you don't need the face plate's camera ho