Raspberry Pi 4B Case & Camera Mount

So i noticed there were a lot of cases and camera mounts and no combos, so I just made this to work with Raspberry Pi 4B that I got and the V2 Pi camera. Not sure if it will work with different models, did not test. Arms are designed to for the ribbon cable to snake through it as needed to come out toward the board, there are groves pictured above to retain the cable. Prints fine without support. Some might need support for the bridge by the sd card slot.Hardware required to assemble.Fan is just a 40mmx10 case fan.(qty: 4) M3x20mm Flat heads with nutsThis are the filters i put on it.https://www.amazon.com/gp/product/B09R9DZ39M/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1Case hardware(qty: 4) M4x12mm Flat heads (Ties top and bottom together)(qty: 2) M4x8mm Flat heads (Holds mount base on on top)(qty: 4) M2x5mm (For mounting the board to the bottom shell, could be SHCS or panheads, the pilot hole is sized for M2 and is only 5mm deep)Arm(qty: 4) M4x25-30mm (Depends on nut you get, 25 w