MakerWorld
Electronics
Go to Model
Raspberry Pi 5 Case
26
Downloads
12
Likes
7
Makes
-You need 3x (Ø5x2mm or Ø5x1,5mm) magnet as shown below.-And 4x (M2) screw for mounting pi to case.-Fix grille to the case with glue.-If you are having trouble with fitting problem, you should set your “Horizonatal Expansion” setting as “-0,1” in your slicer. (for ex. pi doesn't fit in the case or top case doesn't fit with the bottom case or too tight)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
