MakerWorld
Electronics
Ver Modelo
Raspberry Pi 5 Case
26
Descargas
12
Likes
7
Makes
-You need 3x (Ø5x2mm or Ø5x1,5mm) magnet as shown below.-And 4x (M2) screw for mounting pi to case.-Fix grille to the case with glue.-If you are having trouble with fitting problem, you should set your “Horizonatal Expansion” setting as “-0,1” in your slicer. (for ex. pi doesn't fit in the case or top case doesn't fit with the bottom case or too tight)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
