Raspberry Pi 5 Case

Raspberry Pi 5 Case

-The Case Has A lot of Ventilation from all sides, aswell the bottom size (works well for hand warming).
-Optimized to fit the official Raspberry pi 5 active cooler.
-Created a piece for the power button (didn't test the button yet).

Please mind that this is a tight fit according to my printer tolerance.

-Lay the case flat on the printing plate.

-Use Tree Support from printing plate for easy and clean finish for the SD slot and GPIO opening.

- Assembly with 4 pieces of M3 x 20 mm but also you can use M3x18 or M3x21