Thingiverse
Raspberry Pi 5 Case
von TriDeeDesign
3
Downloads
5
Likes
0
Makes
Raspberry Pi 5 Case
-The Case Has A lot of Ventilation from all sides, aswell the bottom size (works well for hand warming).
-Optimized to fit the official Raspberry pi 5 active cooler.
-Created a piece for the power button (didn't test the button yet).
Please mind that this is a tight fit according to my printer tolerance.
-Lay the case flat on the printing plate.
-Use Tree Support from printing plate for easy and clean finish for the SD slot and GPIO opening.
- Assembly with 4 pieces of M3 x 20 mm but also you can use M3x18 or M3x21
-The Case Has A lot of Ventilation from all sides, aswell the bottom size (works well for hand warming).
-Optimized to fit the official Raspberry pi 5 active cooler.
-Created a piece for the power button (didn't test the button yet).
Please mind that this is a tight fit according to my printer tolerance.
-Lay the case flat on the printing plate.
-Use Tree Support from printing plate for easy and clean finish for the SD slot and GPIO opening.
- Assembly with 4 pieces of M3 x 20 mm but also you can use M3x18 or M3x21
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
