Thingiverse
Raspberry Pi 5" Display Case
von lolfil
14
Downloads
13
Likes
0
Makes
Case for using screen separately from raspberry (or using it with any other HDMI device).
Update 27.01.2020: Added case for using screen with RPi and VESA-D(100x100).
Update 23.01.2020: Added back panel with VESA-C (75x75).
Update 22.01.2020: Added adapter to Modular Mounting System
For that screen
Case is 140mm х 90mm х 23.1mm
Have a hole for GPIO(on the back side), HDMI and micro usb.
You can print all parts one by one(front panel, front spacer, back spacer, back panel) or use connected parts (front panel + spacer, back panel + spacer).
Version for RPi can be used with two fans(25mm/30mm/40mm).
Stands is designed for 60 and 45 degrees (you need two of them to use case as table monitor properly).
If you afraid of broken stands you can use reinforced version.
You also needs:
For RPi version: M3x40 - 4
For version with stands M3x30 screw - 4
For version without stands M3x25 screw - 6
M3 nut x 4-6 (depends on configuration)
Update 27.01.2020: Added case for using screen with RPi and VESA-D(100x100).
Update 23.01.2020: Added back panel with VESA-C (75x75).
Update 22.01.2020: Added adapter to Modular Mounting System
For that screen
Case is 140mm х 90mm х 23.1mm
Have a hole for GPIO(on the back side), HDMI and micro usb.
You can print all parts one by one(front panel, front spacer, back spacer, back panel) or use connected parts (front panel + spacer, back panel + spacer).
Version for RPi can be used with two fans(25mm/30mm/40mm).
Stands is designed for 60 and 45 degrees (you need two of them to use case as table monitor properly).
If you afraid of broken stands you can use reinforced version.
You also needs:
For RPi version: M3x40 - 4
For version with stands M3x30 screw - 4
For version without stands M3x25 screw - 6
M3 nut x 4-6 (depends on configuration)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
