Thingiverse
Raspberry Pi & Electronics Control Case
door E_Raw
5
Downloads
6
Likes
0
Makes
This is a component part of a 3D Printer enclosure project: https://www.thingiverse.com/thing:4843545
It contains one Raspberry Pi 4 which runs Octoprint with PSU Control, Enclosure Plugins.
Rpi GPIO are connected to a breakout board with some electronic component to power (12v, 5v, GND) and manage properly:
2x PWN 120mm Fans
1x Neopixel 60 LEDSs strip (RGB)
4x Relay ports
3x 1-wire DS18B20 temperature probes
It contains one Raspberry Pi 4 which runs Octoprint with PSU Control, Enclosure Plugins.
Rpi GPIO are connected to a breakout board with some electronic component to power (12v, 5v, GND) and manage properly:
2x PWN 120mm Fans
1x Neopixel 60 LEDSs strip (RGB)
4x Relay ports
3x 1-wire DS18B20 temperature probes
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
