Raspberry Pi CAM Mount with integrated cable management

This camera mount is for the Raspberry Pi CAM.
The one thing I didn't like about this CAM is the ribbon cable and I wanted a solution that prevented the fragile cable from getting in the way or damaged.
This design has internal passages that hide and protect the cable before exiting at the rear of the beam connected to the base and under the printer to the Raspberry Pi. This was the third design iteration and it worked far better than I had hoped. The cable runs very smoothly without snagging even whilst articulating the arm. It's an optical illusion that the cable follows the "A frame" and was completely unintentional but looks quite good (well, I think so!!)
It's been a long time in the designing/making and resulted in many sacrifices to the 3D printing gods (see last picture!)

You will need 1 of each model although I printed an extra "RPi_CAM_BEAM_100mm_B_v4" to help level the CAM image.

The joints each use an M3 x 20mm Cap Head Screw and nut (design makes this nut captive