Thingiverse
Raspberry Pi camera adjustable support arm
door davidball123
7
Downloads
5
Likes
0
Makes
Raspberry Pi camera adjustable mount by hommepasse.
This design uses a corner support bracket as found on the Ender 5.
The dowel on the support arm (rcb.stl) locates in the
central hole of the Ender 5 support bracket.
The ribbon cable block (rcb.stl) connects to the support arm.
The dowel on the camera housing connector slots
into the hole in the ribbon cable block.
This design uses a corner support bracket as found on the Ender 5.
The dowel on the support arm (rcb.stl) locates in the
central hole of the Ender 5 support bracket.
The ribbon cable block (rcb.stl) connects to the support arm.
The dowel on the camera housing connector slots
into the hole in the ribbon cable block.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
