Raspberry Pi Camera Case V3

A camera case/enclosure for Raspberry Pi Camera

The lid is to be glued on with hot glue (since all of it can be removed if desired)
The screw holes (the ones holding the camera in place) are meant for guiding the drill bit when making holes for the screws of the desired size and type. The depth is around 4mm. The mounting holes on the camera circuit board are Ø 2.1 mm according to design drawings.
Screw size on the mounting brackets is M4.

This is part of a larger project.

Print time: 44 minutes
Filament used: 2.60 meters of PLA

Estimated material cost (PLA): ~0,23 €
(Calculated from 200 m spool with a price of 17,99 € ≈ 0.08995 / m)